On 9/25/06, Petr Vandrovec [off-list ref] wrote:

Michal Suchanek wrote:

quoted

Hello from the Matrox DVI land

For me matrox DVI framebuffer (sort of) works on Linux 2.6.16.19 and
fails on 2.6.17.13.

The DVI support on Matroxes is quite flaky I'd guess.

Ask Matrox to release documentation for their hardware...

Well, it looks like nobody releases the docs for thier graphics hardware...

quoted

I got a matrox g450

01:00.0 VGA compatible controller: Matrox Graphics, Inc. G400/G450 (rev 85)

and I connect it with DVI to a flat panel.

quoted

For X to work I have to use kernel framebuffer to set the videomode
(UseFBDev in X). Otherwise X fails to set the timings correctly
(nothing is visible).
With kernel framebuffer I get an usable videomode in two steps. First
I start the X server, and there is only a message from the monitor
about bad timings. However, after switching to the console and back X
works well. Sometimes the switch is not needed (usually if started
from an already running X server). Works with software suspend as well
(as long as dri is not used).

Are not you using ACER's monitor?  Try just powering monitor off and back on
instead of doing mode switch.

It's an EIZO display. Switching the mode is easier than pressing the
power button but I can try that when I get to start the X server
again.

quoted

With 2.6.17.13 the picture I get is noisy. The lines shift a few
pixels horizontally in various directions. It is much like the results
I got with g550 when there was no screen connected to DVI at startup.
only much more noise (there must be a screen connected to DVI at boot
for the framebuffer to work correctly with DVI - at least it had to
last time I tried).

Upgrade to 2.6.18, it should behave like 2.6.16 does.

I will try. Thanks

Michal

-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys -- and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV