[PATCH 1/2 v3] iio: gyro: Add MPU-3050 device tree bindings
From: Linus Walleij <hidden>
Date: 2016-08-26 07:59:07
Also in:
linux-iio
Subsystem:
iio subsystem and drivers, open firmware and flattened device tree bindings, the rest · Maintainers:
Jonathan Cameron, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
This adds device tree bindings for the MPU-3050 gyroscope. Since it is the first set of bindings for a gyroscope, the folder for it is also created. Cc: devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org Cc: Peter Rosin <redacted> Signed-off-by: Linus Walleij <redacted> --- ChangeLog v2->v3: - Augmented device tree bindings to reflect Peter Rosins now merged I2C gate bindings. ChangeLog v1->v2: - Not yet convered to use i2c-gate as I'm waiting for that patch set to stabilize. --- .../bindings/iio/gyroscope/invensense,mpu3050.txt | 46 ++++++++++++++++++++++ 1 file changed, 46 insertions(+) create mode 100644 Documentation/devicetree/bindings/iio/gyroscope/invensense,mpu3050.txt
diff --git a/Documentation/devicetree/bindings/iio/gyroscope/invensense,mpu3050.txt b/Documentation/devicetree/bindings/iio/gyroscope/invensense,mpu3050.txt
new file mode 100644
index 000000000000..b0d3b59966bc
--- /dev/null
+++ b/Documentation/devicetree/bindings/iio/gyroscope/invensense,mpu3050.txt@@ -0,0 +1,46 @@ +Invensense MPU-3050 Gyroscope device tree bindings + +Required properties: + - compatible : should be "invensense,mpu3050" + - reg : the I2C address of the sensor + +Optional properties: + - interrupt-parent : should be the phandle for the interrupt controller + - interrupts : interrupt mapping for the trigger interrupt from the + internal oscillator. The following IRQ modes are supported: + IRQ_TYPE_EDGE_RISING, IRQ_TYPE_EDGE_FALLING, IRQ_TYPE_LEVEL_HIGH and + IRQ_TYPE_LEVEL_LOW. The driver should detect and configure the hardware + for the desired interrupt type. + - vdd-supply : supply regulator for the main power voltage. + - vlogic-supply : supply regulator for the signal voltage. + - mount-matrix : see iio/mount-matrix.txt + +Optional subnodes: + - The MPU-3050 will pass through and forward the I2C signals from the + incoming I2C bus, alternatively drive traffic to a slave device (usually + an accelerometer) on its own initiative. Therefore is supports a subnode + i2c gate node. For details see: i2c/i2c-gate.txt + +Example: + +mpu3050@68 { + compatible = "invensense,mpu3050"; + reg = <0x68>; + interrupt-parent = <&foo>; + interrupts = <12 IRQ_TYPE_EDGE_FALLING>; + vdd-supply = <&bar>; + vlogic-supply = <&baz>; + + /* External I2C interface */ + i2c-gate { + #address-cells = <1>; + #size-cells = <0>; + + fnord@18 { + compatible = "fnord"; + reg = <0x18>; + interrupt-parent = <&foo>; + interrupts = <13 IRQ_TYPE_EDGE_FALLING>; + }; + }; +};
--
2.7.4