[PATCH] crypto: talitos: request irq after tasklet_init()

The talitos interrupt handlers schedule priv->done_task[] via
tasklet_schedule().  In probe(), talitos_probe_irq() ran before
tasklet_init(), so an interrupt arriving during that window (a shared
IRQ, or a completion pending from an earlier transmission) would
schedule an uninitialized tasklet.

Move talitos_probe_irq() after the tasklet_init() calls so the
tasklets are fully set up before interrupts are enabled.  This matches
remove(), which frees the IRQs before killing the tasklets.

Assisted-by: opencode:big-pickle
Signed-off-by: Rosen Penev <redacted>
---
 drivers/crypto/talitos.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/crypto/talitos.c b/drivers/crypto/talitos.c
index 41a87d7c30a0..da08cf9615c9 100644
--- a/drivers/crypto/talitos.c
+++ b/drivers/crypto/talitos.c

@@ -3481,10 +3481,6 @@ static int talitos_probe(struct platform_device *ofdev)
 		stride = TALITOS2_CH_STRIDE;
 	}
 
-	err = talitos_probe_irq(ofdev);
-	if (err)
-		goto err_out;
-
 	if (has_ftr_sec1(priv)) {
 		if (priv->num_channels == 1)
 			tasklet_init(&priv->done_task[0], talitos1_done_ch0,

@@ -3507,6 +3503,10 @@ static int talitos_probe(struct platform_device *ofdev)
 		}
 	}
 
+	err = talitos_probe_irq(ofdev);
+	if (err)
+		goto err_out;
+
 	priv->fifo_len = roundup_pow_of_two(priv->chfifo_len);
 
 	for (i = 0; i < priv->num_channels; i++) {

-- 
2.55.0