[PATCH v1 1/1] ARM: orion/gpio: Get rid of unused first parameter in orion_gpio_init()

Subsystems: arm port, arm/marvell dove/mv78xx0/orion soc support, the rest

STALE1694d

3 messages, 2 authors, 2021-12-14 · open the first message on its own page

[PATCH v1 1/1] ARM: orion/gpio: Get rid of unused first parameter in orion_gpio_init()

From: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Date: 2021-12-14 13:32:43

The OF node pointer is always NULL, get rid of unused parameter in
orion_gpio_init(). As a side effect it will allow to switch GPIO
library to the fwnode API, as well as in case of resurrecting it here
it should be fwnode_handle anyways.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
 arch/arm/mach-dove/irq.c                      | 11 +++--------
 arch/arm/mach-mv78xx0/irq.c                   |  3 +--
 arch/arm/mach-orion5x/irq.c                   |  3 +--
 arch/arm/plat-orion/gpio.c                    |  8 ++------
 arch/arm/plat-orion/include/plat/orion-gpio.h |  3 +--
 5 files changed, 8 insertions(+), 20 deletions(-)
diff --git a/arch/arm/mach-dove/irq.c b/arch/arm/mach-dove/irq.c
index 31ccbcee2627..c7ad6e5c37b0 100644
--- a/arch/arm/mach-dove/irq.c
+++ b/arch/arm/mach-dove/irq.c
@@ -73,12 +73,7 @@ void __init dove_init_irq(void)
 	/*
 	 * Initialize gpiolib for GPIOs 0-71.
 	 */
-	orion_gpio_init(NULL, 0, 32, DOVE_GPIO_LO_VIRT_BASE, 0,
-			IRQ_DOVE_GPIO_START, gpio0_irqs);
-
-	orion_gpio_init(NULL, 32, 32, DOVE_GPIO_HI_VIRT_BASE, 0,
-			IRQ_DOVE_GPIO_START + 32, gpio1_irqs);
-
-	orion_gpio_init(NULL, 64, 8, DOVE_GPIO2_VIRT_BASE, 0,
-			IRQ_DOVE_GPIO_START + 64, gpio2_irqs);
+	orion_gpio_init(0, 32, DOVE_GPIO_LO_VIRT_BASE, 0, IRQ_DOVE_GPIO_START, gpio0_irqs);
+	orion_gpio_init(32, 32, DOVE_GPIO_HI_VIRT_BASE, 0, IRQ_DOVE_GPIO_START + 32, gpio1_irqs);
+	orion_gpio_init(64, 8, DOVE_GPIO2_VIRT_BASE, 0, IRQ_DOVE_GPIO_START + 64, gpio2_irqs);
 }
diff --git a/arch/arm/mach-mv78xx0/irq.c b/arch/arm/mach-mv78xx0/irq.c
index 788569e960e1..0b5f055ca1c3 100644
--- a/arch/arm/mach-mv78xx0/irq.c
+++ b/arch/arm/mach-mv78xx0/irq.c
@@ -67,7 +67,6 @@ void __init mv78xx0_init_irq(void)
 	 * registers for core #1 are at an offset of 0x18 from those of
 	 * core #0.)
 	 */
-	orion_gpio_init(NULL, 0, 32, GPIO_VIRT_BASE,
-			mv78xx0_core_index() ? 0x18 : 0,
+	orion_gpio_init(0, 32, GPIO_VIRT_BASE, mv78xx0_core_index() ? 0x18 : 0,
 			IRQ_MV78XX0_GPIO_START, gpio0_irqs);
 }
diff --git a/arch/arm/mach-orion5x/irq.c b/arch/arm/mach-orion5x/irq.c
index ac4af2283bef..62d0f4877b2a 100644
--- a/arch/arm/mach-orion5x/irq.c
+++ b/arch/arm/mach-orion5x/irq.c
@@ -49,6 +49,5 @@ void __init orion5x_init_irq(void)
 	/*
 	 * Initialize gpiolib for GPIOs 0-31.
 	 */
-	orion_gpio_init(NULL, 0, 32, GPIO_VIRT_BASE, 0,
-			IRQ_ORION5X_GPIO_START, gpio0_irqs);
+	orion_gpio_init(0, 32, GPIO_VIRT_BASE, 0, IRQ_ORION5X_GPIO_START, gpio0_irqs);
 }
diff --git a/arch/arm/plat-orion/gpio.c b/arch/arm/plat-orion/gpio.c
index 734f0be4f14a..3ef9ecdd6343 100644
--- a/arch/arm/plat-orion/gpio.c
+++ b/arch/arm/plat-orion/gpio.c
@@ -516,8 +516,7 @@ static void orion_gpio_mask_irq(struct irq_data *d)
 	irq_gc_unlock(gc);
 }
 
-void __init orion_gpio_init(struct device_node *np,
-			    int gpio_base, int ngpio,
+void __init orion_gpio_init(int gpio_base, int ngpio,
 			    void __iomem *base, int mask_offset,
 			    int secondary_irq_base,
 			    int irqs[4])
@@ -545,9 +544,6 @@ void __init orion_gpio_init(struct device_node *np,
 	ochip->chip.base = gpio_base;
 	ochip->chip.ngpio = ngpio;
 	ochip->chip.can_sleep = 0;
-#ifdef CONFIG_OF
-	ochip->chip.of_node = np;
-#endif
 	ochip->chip.dbg_show = orion_gpio_dbg_show;
 
 	spin_lock_init(&ochip->lock);
@@ -605,7 +601,7 @@ void __init orion_gpio_init(struct device_node *np,
 			       IRQ_NOREQUEST, IRQ_LEVEL | IRQ_NOPROBE);
 
 	/* Setup irq domain on top of the generic chip. */
-	ochip->domain = irq_domain_add_legacy(np,
+	ochip->domain = irq_domain_add_legacy(NULL,
 					      ochip->chip.ngpio,
 					      ochip->secondary_irq_base,
 					      ochip->secondary_irq_base,
diff --git a/arch/arm/plat-orion/include/plat/orion-gpio.h b/arch/arm/plat-orion/include/plat/orion-gpio.h
index e856b073a9c8..25a2963e0e0f 100644
--- a/arch/arm/plat-orion/include/plat/orion-gpio.h
+++ b/arch/arm/plat-orion/include/plat/orion-gpio.h
@@ -30,8 +30,7 @@ int orion_gpio_led_blink_set(struct gpio_desc *desc, int state,
 void orion_gpio_set_valid(unsigned pin, int mode);
 
 /* Initialize gpiolib. */
-void __init orion_gpio_init(struct device_node *np,
-			    int gpio_base, int ngpio,
+void __init orion_gpio_init(int gpio_base, int ngpio,
 			    void __iomem *base, int mask_offset,
 			    int secondary_irq_base,
 			    int irq[4]);
-- 
2.33.0


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

Re: [PATCH v1 1/1] ARM: orion/gpio: Get rid of unused first parameter in orion_gpio_init()

From: "Russell King (Oracle)" <linux@armlinux.org.uk>
Date: 2021-12-14 13:41:39

On Tue, Dec 14, 2021 at 03:32:43PM +0200, Andy Shevchenko wrote:
The OF node pointer is always NULL, get rid of unused parameter in
orion_gpio_init(). As a side effect it will allow to switch GPIO
library to the fwnode API, as well as in case of resurrecting it here
it should be fwnode_handle anyways.
Please ensure the new code follows the existing style - especially in
terms of wrapping. Some of us still use 80 columns as a general rule.
Thanks.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

Re: [PATCH v1 1/1] ARM: orion/gpio: Get rid of unused first parameter in orion_gpio_init()

From: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Date: 2021-12-14 13:59:50

On Tue, Dec 14, 2021 at 01:41:29PM +0000, Russell King (Oracle) wrote:
On Tue, Dec 14, 2021 at 03:32:43PM +0200, Andy Shevchenko wrote:
quoted
The OF node pointer is always NULL, get rid of unused parameter in
orion_gpio_init(). As a side effect it will allow to switch GPIO
library to the fwnode API, as well as in case of resurrecting it here
it should be fwnode_handle anyways.
Please ensure the new code follows the existing style - especially in
terms of wrapping. Some of us still use 80 columns as a general rule.
Thanks.
Ah, okay, I will fix that for v2.

-- 
With Best Regards,
Andy Shevchenko



_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help