[PATCH linux dev-5.10] ARM: dts: everest: Add 'factory-reset-toggle' as GPIOF6

The state of this GPIO determines whether a factory reset has been
requested. If a physical switch is used, it can be high or low. During boot,
the software checks and records the state of this switch. If it is different
than the previous recorded state, then the read-write portions of memory are
reformatted.

Signed-off-by: Isaac Kurth <redacted>
---
 arch/arm/boot/dts/aspeed-bmc-ibm-everest.dts | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/aspeed-bmc-ibm-everest.dts b/arch/arm/boot/dts/aspeed-bmc-ibm-everest.dts
index 83fc29309154..73c8f780e5b1 100644
--- a/arch/arm/boot/dts/aspeed-bmc-ibm-everest.dts
+++ b/arch/arm/boot/dts/aspeed-bmc-ibm-everest.dts

@@ -241,7 +241,8 @@ &gpio0 {
 	/*D0-D7*/	"","","","","","","","",
 	/*E0-E7*/	"","","","","","","","",
 	/*F0-F7*/	"PIN_HOLE_RESET_IN_N","","",
-				"PIN_HOLE_RESET_OUT_N","","","","",
+				"PIN_HOLE_RESET_OUT_N","","",
+				"factory-reset-toggle","",
 	/*G0-G7*/	"","","","","","","","",
 	/*H0-H7*/	"led-rtc-battery","led-bmc","led-rear-enc-id0","led-rear-enc-fault0","","","","",
 	/*I0-I7*/	"","","","","","","","",

-- 
2.25.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel