# Re: \[PATCH v4 11/12\] \[RFC\] firmware: arm\_scmi: Add sync\_cmds\_atomic\_replies transport flag

- From: Florian Fainelli \<f.fainelli@gmail.com\>
- Date: 2021-08-25 16:38:33 
- List: linux-arm-kernel
- Page: https://ratatoskr.run/linux-arm-kernel/2021/08/1488921
- Thread: https://ratatoskr.run/linux-arm-kernel/2021/08/1487075/t.md

```text


On 8/24/2021 3:59 PM, Cristian Marussi wrote:
> A flag is added to let the transport signal the core that its handling of
> synchronous command messages implies that, after .send_message has returned
> successfully, the requested command can be assumed to be fully and
> completely executed on SCMI platform side so that any possible response
> value is already immediately available to be retrieved by a .fetch_reponse:
> in other words the polling phase can be skipped in such a case and the
> response values accessed straight away.
>
> Note that all of the above applies only when polling mode of operation was
> selected by the core: if instead a completion IRQ was found to be available
> the normal response processing path based on completions will still be
> followed.

This might actually have to be settable on a per-message basis ideally since we may be transporting short lived SCMI messages for which the completion can be done at SMC time, and long lived SCMI messages (e.g.: involving a voltage change) for which we would prefer a completion interrupt. Jim, what do you think?
-- 
Florian

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
```
