[PATCH 11/12] dt-bindings: usb: mtu3: remove dummy clocks and add optional ones
From: chunfeng.yun@mediatek.com (Chunfeng Yun)
Date: 2017-09-28 00:17:49
Also in:
linux-devicetree, linux-mediatek, lkml
Subsystem:
mediatek usb3 drd ip driver, open firmware and flattened device tree bindings, the rest, usb subsystem · Maintainers:
Chunfeng Yun, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds, Greg Kroah-Hartman
Remove dummy clocks for usb wakeup and add optional ones for mcu_bus and dma_bus bus. Signed-off-by: Chunfeng Yun <chunfeng.yun@mediatek.com> --- .../devicetree/bindings/usb/mediatek,mtu3.txt | 10 ++++------ 1 file changed, 4 insertions(+), 6 deletions(-)
diff --git a/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt b/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt
index 7c611d1..49c982b 100644
--- a/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt
+++ b/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt@@ -14,9 +14,9 @@ Required properties: - vusb33-supply : regulator of USB avdd3.3v - clocks : a list of phandle + clock-specifier pairs, one for each entry in clock-names - - clock-names : must contain "sys_ck" and "ref_ck" for clock of controller; - "wakeup_deb_p0" and "wakeup_deb_p1" are optional, they are - depends on "mediatek,enable-wakeup" + - clock-names : must contain "sys_ck" for clock of controller, + the following clocks are optional: + "ref_ck", "mcu_ck" and "dam_ck"; - phys : a list of phandle + phy specifier pairs - dr_mode : should be one of "host", "peripheral" or "otg", refer to usb/generic.txt
@@ -65,9 +65,7 @@ ssusb: usb at 11271000 { clocks = <&topckgen CLK_TOP_USB30_SEL>, <&clk26m>, <&pericfg CLK_PERI_USB0>, <&pericfg CLK_PERI_USB1>; - clock-names = "sys_ck", "ref_ck", - "wakeup_deb_p0", - "wakeup_deb_p1"; + clock-names = "sys_ck", "ref_ck"; vusb33-supply = <&mt6397_vusb_reg>; vbus-supply = <&usb_p0_vbus>; extcon = <&extcon_usb>;
--
1.7.9.5