[PATCH 1/6] net: stmmac: support future possible different internal phy mode
From: clabbe.montjoie@gmail.com (Corentin Labbe)
Date: 2017-06-27 09:30:21
Also in:
linux-devicetree, lkml, netdev
Subsystem:
networking drivers, stmmac ethernet driver, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
The current way to find if the phy is internal is to compare DT phy-mode and emac_variant/internal_phy. But it will negate a possible future SoC where an external PHY use the same phy mode than the internal one. By using phy-mode = "internal" we permit to have an external PHY with the same mode than the internal one. Reported-by: Andr? Przywara <andre.przywara@arm.com> Signed-off-by: Corentin Labbe <clabbe.montjoie@gmail.com> --- drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c | 10 +++++++--- 1 file changed, 7 insertions(+), 3 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c
index fffd6d5fc907..6c2d1da05588 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c@@ -638,7 +638,7 @@ static int sun8i_dwmac_set_syscon(struct stmmac_priv *priv) { struct sunxi_priv_data *gmac = priv->plat->bsp_priv; struct device_node *node = priv->device->of_node; - int ret; + int ret, phy_interface; u32 reg, val; regmap_read(gmac->regmap, SYSCON_EMAC_REG, &val);
@@ -718,7 +718,11 @@ static int sun8i_dwmac_set_syscon(struct stmmac_priv *priv) if (gmac->variant->support_rmii) reg &= ~SYSCON_RMII_EN; - switch (priv->plat->interface) { + phy_interface = priv->plat->interface; + /* if PHY is internal, select the mode (xMII) used by the SoC */ + if (gmac->use_internal_phy) + phy_interface = gmac->variant->internal_phy; + switch (phy_interface) { case PHY_INTERFACE_MODE_MII: /* default */ break;
@@ -932,7 +936,7 @@ static int sun8i_dwmac_probe(struct platform_device *pdev) } plat_dat->interface = of_get_phy_mode(dev->of_node); - if (plat_dat->interface == gmac->variant->internal_phy) { + if (plat_dat->interface == PHY_INTERFACE_MODE_INTERNAL) { dev_info(&pdev->dev, "Will use internal PHY\n"); gmac->use_internal_phy = true; gmac->ephy_clk = of_clk_get(plat_dat->phy_node, 0);
--
2.13.0