[PATCH v2 3/6] mtd: nand: vf610_nfc: add device tree bindings
From: stefan@agner.ch (Stefan Agner)
Date: 2015-03-09 16:40:31
Also in:
linux-devicetree, lkml
Subsystem:
memory technology devices (mtd), open firmware and flattened device tree bindings, the rest · Maintainers:
Miquel Raynal, Richard Weinberger, Vignesh Raghavendra, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Signed-off-by: Bill Pringlemeir <redacted> Signed-off-by: Stefan Agner <stefan@agner.ch> --- .../devicetree/bindings/mtd/vf610-nfc.txt | 39 ++++++++++++++++++++++ 1 file changed, 39 insertions(+) create mode 100644 Documentation/devicetree/bindings/mtd/vf610-nfc.txt
diff --git a/Documentation/devicetree/bindings/mtd/vf610-nfc.txt b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt
new file mode 100644
index 0000000..312c872
--- /dev/null
+++ b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt@@ -0,0 +1,39 @@ +Freescale's NAND flash controller (NFC) + +This variant of the Freescale NAND flash controller (NFC) is on Vybrid (vf610), +MPC5125, MCF54418 and Kinetis K70. + +Required properties: +- compatible: "fsl,vf610-nfc" +- reg: Address range of the mtd chip +- interrupts: Should contain the STMMAC interrupts +- nand-bus-width: see nand.txt +- nand-ecc-mode: see nand.txt +- nand-on-flash-bbt: see nand.txt +- clock-frequency : Optional clock rate to NFC in Hz +- #address-cells, #size-cells : Must be present if the device has sub-nodes + representing partitions. + +Required properties for hardware ECC: +- nand-ecc-strength: supported strengths are 24 and 32 (see nand.txt) +- nand-ecc-step-size: step size equals page size, currently only 2k pages are + supported + +Example: + + nfc: nand at 400e0000 { + compatible = "fsl,vf610-nfc"; + #address-cells = <1>; + #size-cells = <1>; + reg = <0x400e0000 0x4000>; + interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&clks VF610_CLK_NFC>; + clock-names = "nfc"; + assigned-clocks = <&clks VF610_CLK_NFC>; + assigned-clock-rates = <33000000>; + nand-bus-width = <8>; + nand-ecc-mode = "hw"; + nand-on-flash-bbt; + nand-ecc-strength = <32>; + nand-ecc-step-size = <2048>; + };
--
2.3.1