# \[PATCH, RFC 15/22\] USB: EHCI: remove bogus \#error

- From: Alan Stern \<stern@rowland.harvard.edu\>
- Date: 2013-05-02 17:34:56 
- List: linux-arm-kernel
- Page: https://ratatoskr.run/linux-arm-kernel/2013/05/4043018
- Thread: https://ratatoskr.run/linux-arm-kernel/2013/05/4042941/t.md

```text
On Thu, 2 May 2013, Arnd Bergmann wrote:

> The EHCI host controller driver can be built standalone now,
> without enabling any of the available bus glue drivers, so
> there is not really a reason to error out here:

On the other hand, there's no reason to build the driver without any 
bus glue.  It wouldn't do anything.

> drivers/usb/host/ehci-hcd.c:1303:2: error:
>  #error "missing bus glue for ehci-hcd"  #error "missing bus glue for ehci-hcd"
> 
> The alternative would be to change the Kconfig code to build
> the ehci-hcd module only if any of the symbols below are
> in fact enabled.
> 
> Cc: Alan Stern <stern@rowland.harvard.edu>
> Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
> Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Acked-by: Alan Stern <stern@rowland.harvard.edu>
```
