[PATCH 1/1] MTD: atmel nand: fix gpio missing request

Subsystems: memory technology devices (mtd), nand flash subsystem, the rest

STALE5132d

3 messages, 2 authors, 2012-08-17 · open the first message on its own page

[PATCH 1/1] MTD: atmel nand: fix gpio missing request

From: Jean-Christophe PLAGNIOL-VILLARD <hidden>
Date: 2012-07-12 05:30:36

without this the gpio will not be muxed as a gpio by the current custom pinmux
or later by the pinctrl

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <redacted>
Cc: Nicolas Ferre <redacted>
---
 drivers/mtd/nand/atmel_nand.c |   25 ++++++++++++++++++++++++-
 1 file changed, 24 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index 97ac671..fce649a 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c

@@ -583,8 +583,24 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
 	nand_chip->IO_ADDR_W = host->io_base;
 	nand_chip->cmd_ctrl = atmel_nand_cmd_ctrl;
 
-	if (gpio_is_valid(host->board.rdy_pin))
+	if (gpio_is_valid(host->board.rdy_pin)) {
+		res = gpio_request(host->board.rdy_pin, "nand_rdy");
+		if (res) {
+			dev_err(&pdev->dev,
+				"can't request rdy gpio %d\n", host->board.rdy_pin);
+			goto err_ecc_ioremap;
+		}
 		nand_chip->dev_ready = atmel_nand_device_ready;
+	}
+
+	if (gpio_is_valid(host->board.enable_pin)) {
+		res = gpio_request(host->board.enable_pin, "nand_enable");
+		if (res) {
+			dev_err(&pdev->dev,
+				"can't request enable gpio %d\n", host->board.enable_pin);
+			goto err_ecc_ioremap;
+		}
+	}
 
 	nand_chip->ecc.mode = host->board.ecc_mode;

@@ -622,6 +638,13 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
 	atmel_nand_enable(host);
 
 	if (gpio_is_valid(host->board.det_pin)) {
+		res = gpio_request(host->board.det_pin, "nand_det");
+		if (res) {
+			dev_err(&pdev->dev,
+				"can't request det gpio %d\n", host->board.det_pin);
+			goto err_no_card;
+		}
+
 		if (gpio_get_value(host->board.det_pin)) {
 			printk(KERN_INFO "No SmartMedia card inserted.\n");
 			res = -ENXIO;

-- 
1.7.10

[PATCH 1/1 v2] MTD: atmel nand: fix gpio missing request

From: Jean-Christophe PLAGNIOL-VILLARD <hidden>
Date: 2012-07-12 08:31:08

without this the gpio will not be muxed as a gpio by the current custom pinmux
or later by the pinctrl

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <redacted>
Cc: Nicolas Ferre <redacted>
---
V2:

	set the direction too

	today this is invisible as you mostly boot from nand and the
	bootloader configured them but if you load the kernel via nor you need
	to do it

Best Regards,
J.
 drivers/mtd/nand/atmel_nand.c |   56 ++++++++++++++++++++++++++++++++++++++++-
 1 file changed, 55 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index 97ac671..eef9f80 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c

@@ -583,8 +583,39 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
 	nand_chip->IO_ADDR_W = host->io_base;
 	nand_chip->cmd_ctrl = atmel_nand_cmd_ctrl;
 
-	if (gpio_is_valid(host->board.rdy_pin))
+	if (gpio_is_valid(host->board.rdy_pin)) {
+		res = gpio_request(host->board.rdy_pin, "nand_rdy");
+		if (res < 0) {
+			dev_err(&pdev->dev,
+				"can't request rdy gpio %d\n", host->board.rdy_pin);
+			goto err_ecc_ioremap;
+		}
+
+		res = gpio_direction_input(host->board.rdy_pin);
+		if (res < 0) {
+			dev_err(&pdev->dev,
+				"can't request input direction rdy gpio %d\n", host->board.rdy_pin);
+			goto err_ecc_ioremap;
+		}
+
 		nand_chip->dev_ready = atmel_nand_device_ready;
+	}
+
+	if (gpio_is_valid(host->board.enable_pin)) {
+		res = gpio_request(host->board.enable_pin, "nand_enable");
+		if (res < 0) {
+			dev_err(&pdev->dev,
+				"can't request enable gpio %d\n", host->board.enable_pin);
+			goto err_ecc_ioremap;
+		}
+
+		res = gpio_direction_output(host->board.enable_pin, 1);
+		if (res < 0) {
+			dev_err(&pdev->dev,
+				"can't request output direction enable gpio %d\n", host->board.enable_pin);
+			goto err_ecc_ioremap;
+		}
+	}
 
 	nand_chip->ecc.mode = host->board.ecc_mode;

@@ -622,6 +653,20 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
 	atmel_nand_enable(host);
 
 	if (gpio_is_valid(host->board.det_pin)) {
+		res = gpio_request(host->board.det_pin, "nand_det");
+		if (res < 0) {
+			dev_err(&pdev->dev,
+				"can't request det gpio %d\n", host->board.det_pin);
+			goto err_no_card;
+		}
+
+		res = gpio_direction_input(host->board.det_pin);
+		if (res < 0) {
+			dev_err(&pdev->dev,
+				"can't request input direction det gpio %d\n", host->board.det_pin);
+			goto err_no_card;
+		}
+
 		if (gpio_get_value(host->board.det_pin)) {
 			printk(KERN_INFO "No SmartMedia card inserted.\n");
 			res = -ENXIO;

@@ -738,6 +783,15 @@ static int __exit atmel_nand_remove(struct platform_device *pdev)
 
 	atmel_nand_disable(host);
 
+	if (gpio_is_valid(host->board.det_pin))
+		gpio_free(host->board.det_pin);
+
+	if (gpio_is_valid(host->board.enable_pin))
+		gpio_free(host->board.enable_pin);
+
+	if (gpio_is_valid(host->board.rdy_pin))
+		gpio_free(host->board.rdy_pin);
+
 	if (host->ecc)
 		iounmap(host->ecc);

-- 
1.7.10

[PATCH 1/1 v2] MTD: atmel nand: fix gpio missing request

From: dedekind1@gmail.com (Artem Bityutskiy)
Date: 2012-08-17 11:29:44

On Thu, 2012-07-12 at 10:31 +0200, Jean-Christophe PLAGNIOL-VILLARD
wrote:

without this the gpio will not be muxed as a gpio by the current custom pinmux
or later by the pinctrl

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <redacted>
Cc: Nicolas Ferre <redacted>

Pushed to l2-mtd.git, thanks!

-- 
Best Regards,
Artem Bityutskiy
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 836 bytes
Desc: This is a digitally signed message part
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20120817/7a694f35/attachment.sig>

`h`	back out one level
`j`	next message in thread
`k`	previous message in thread
`l`	drill in
`Esc`	close help / fold thread tree
`?`	toggle this help