[ v2 resend PATCH 1/1] ARM: i.MX28: shift frac value in _CLK_SET_RATE

Noticed when setting SSP0 in clk_set_rate, _CLK_SET_RATE attempts to reset the clock divider for the SSP0 parent clock, in this case IO0FRAC. Bits 24-29 of HW_CLKCTRL_FRAC0 are cleared correctly, but when the new frac value is written the value isn't shifted up to write the correct bit-field.  This results in IO0FRAC being set to 0 and CPUFRAC being corrupted.

This should occur when writing IO1FRAC, EMIFRAC in HW_CLKCTRL_FRAC0 and GPMIFRAC, HSADCFRAC in HW_CLKCTRL_FRAC1.

Tested on custom i.MX28 board with SSP0 SPI driver.

Signed-off-by: Matt Burtch <redacted>
---
 Fixed whitespace formatting per Shawn Guo.

 arch/arm/mach-mxs/clock-mx28.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/arch/arm/mach-mxs/clock-mx28.c b/arch/arm/mach-mxs/clock-mx28.c
index 5dcc59d..ba53227 100644
--- a/arch/arm/mach-mxs/clock-mx28.c
+++ b/arch/arm/mach-mxs/clock-mx28.c

@@ -349,7 +349,7 @@ static int name##_set_rate(struct clk *clk, unsigned long rate)		\
 									\
 		reg = __raw_readl(CLKCTRL_BASE_ADDR + HW_CLKCTRL_##fr);	\
 		reg &= ~BM_CLKCTRL_##fr##_##fs##FRAC;			\
-		reg |= frac;						\
+		reg |= frac << BP_CLKCTRL_##fr##_##fs##FRAC;		\
 		__raw_writel(reg, CLKCTRL_BASE_ADDR + HW_CLKCTRL_##fr);	\
 	}								\
 									\

-- 
1.7.1