Hi,
I am using ARM9 based s3c2416 processor. The SoC has one USB host
controller and one USB host/device controller. What are the
register settings that should be done to enable both USB
interfaces as USB host controller. ? There is a register PHYCTRL
with address 0x4C00_0080. Its bit[0] says something on USB host
mode and USB device mode. Is it this register which I should
work on or any more register configurations are required ?
Thank You
GIGIN
GIGIN JOSE wrote:
Hi,
Hi
I am using ARM9 based s3c2416 processor. The SoC has one USB host
controller and one USB host/device controller. What are the
register settings that should be done to enable both USB
interfaces as USB host controller. ? There is a register PHYCTRL
with address 0x4C00_0080. Its bit[0] says something on USB host
mode and USB device mode. Is it this register which I should
work on or any more register configurations are required ?
(Cc'ed Kyoungil Kim)
As I know, your setting is right, but you need to connect (serial
interface) between USB2.0 PHY and USB 1.1 Host on board.
Thanks.
Best regards,
Kgene.
--
Kukjin Kim [off-list ref], Senior Engineer,
SW Solution Development Team, Samsung Electronics Co., Ltd.