John,

Gateway mode is something different (read about it in the wiki) -- what you want to look at with batctl is "originators" which show you surrounding nodes with link quality.  If you want to do routing you'll have to do something different; batman-adv as you set it up is like plugging your computers into the same switch.

Good luck,

RG

John Tobias [off-list ref] wrote:

Hi Guys,

I have two devices, both of them have eth0, wlan0. I followed the
BATMAN quick start guide
(http://www.open-mesh.org/wiki/batman-adv/Quick-start-guide) mixing
non-BATMAN.
The bat0, eth0, wlan0 on both devices were set to 0.0.0.0 and the
mesh-bridge on dev1 was set to 192.168.10.1 and on dev2 was set to
192.168.10.2. Both devices can ping to each other.

When I execute "batctl gwl", I was getting "No gateways in range ...".

My question is, do you have a sample step-by-step procedures to bring
up the batman correctly?.

Regards,

john

N�r���x�jب��'�ح�׬jw�y�k�x�r���x�jب���)��jx�����%y�k�x�
���x�jب������-��
nuѩ݊�
��%�˫z+,����\��h�y�h��yȩ���{^�םo+azǧu��~�b�g���
N�zf����j|��W�����h���p��b��ަ�)�'�j���ا���y���^��^�Ǩ~�^�wb�'njZ+z{b�+h�&��j��u�޲ǝN�j����hm��{���y�(�'�����u�kz�vW���0�����h��ay�i��,y�^�h��*'��n���
��z�l!"'p���Z���q�y�a�Ǧj)b��뢺ey�
��b+azǧu�ڝئ��bjץ�ץzע���*.�̬�铅��ʋ